Hello,
I have created a simple project with videos. The audio of the videos are muted
I added an off voice to the project to explain the video.
On the timeline, it's perfect.
When I render, the audio is delayed for several seconds after less than one minute and it is cut when a new clip starts.
I extended the video to be 3 seconds longer, but when rendering, KDENLIVE is dropping some framen, and it ends with the same problem: the audio is delayed and cut.
I restarted the project and it's the same.

Has anyone encoutered something similar ?

Thank you for your help.

yep.. and on my case the issue was the comma decimal point ( on my region, the comma is the decimal separator.. and not the point ) maybe this is also your issue.

Hi Bartooni,
Thank you for the idea. I have the same region definition.
Is it something to define in WIndows or in KDENLIVE ?
Something strange as I did not had this before. Only on this specific project. ... Or the delay was not noticeable ...😉

Good evening Bartoloni,
I changed the parameter in windows and ... it works.
THANK YOU !
Maybe because previously I was using video from the Go PRo and from my Samsung, the frame rate was difetent: a round number of fram 30 or 60. Here it was 29.xxx, So the decimal is important and not before.
Well, I'm happy to get a solution, but this seems so obvious that it should be compatible withe any region definition that I would not have found this without your help.

this is a long long story
https://invent.kde.org/kde/kdenlive/issues/78

Thank you for the idea. I have the same region definition.
Is it something to define in WIndows or in KDENLIVE ?

this seems related (almost always) to Windows version, there are a very low amount of report from Linux users...

Teh comma/point issue is fixed with upcoming version 20.08.0.