1. I could use the dbus-msvc-1.2.4 in windows XP(VS2008/Qt4.6.2) and in ubuntu(qt4.6.2).

2. now I run car&controller on the arm platform,the controller always show "disconnect". i have make sure that the "./dbus-daemon --config-file=session.conf" and the car are running.
i have made some attempt:

A: I download the cross-compiled dbus-daemon and session.conf to the arm-board. Then I could run the "./dbus-daemon --config-file=session.conf" command in the Super terminal, and the command is in the ps list.

B: I download the cross-compiled dbus-launch to the arm-board and add relative content to the arm file system. I could run the "./dbus-launch" and "./dbus-launch --auto-syntax" in the Super terminal too.

But even if i could find these commmands in the ps list, the controller still show "disconnect".

please tell me what should i do in order to use dbus on the arm Platform. Maybe the file system should be modified and should include something?

Thanks very much for any advice!

Please avoid posting again your question: (viewtopic.php?f=64&t=89763&p=167718#p167718).