Hey guys,

I'm just starting out with kdenlive, and I'm using kdenlive 0.7.3...

I took a long piece of video I shot with my digital camera (approx 1.3GB) and dropped it into kdenlive. I set in and out points for a clip, then dropped the clip onto the timeline. At this point if I render the result I end up with a clip of the correct length, but from the wrong place in the original video and the audio is off. I can fix the audio by splitting it from the clip, ungrouping it, and shifting it over the amount that it's off. However the big problem is that the resulting rendered file has the wrong in and out points from the original video.

UPDATE: as I was writing this message, I tried saving the render to a different output format. When I save as an MPEG file I don't see this problem. It only happens if I save the file as an NTSC AVI file.

http://www.kdenlive.org/bug-reports
Please read step 1 and step 2.