Hi,

I have rendered a video succesfully. I didn;t notice it at first, but the last 2 clips are missing (a white noise clip and a picture clip).

Is there any way to force kdenlive to render until a specific length?

Thanks

Make sure you are not using the Selected Zone Option in the render dialog. See http://userbase.kde.org/Kdenlive/Manual ... one_Option

I have selected "full project".

So it is not that then.

Do you have a title clip at the end of your project

http://kdenlive.org/mantis/view.php?id=2609 "0002609: rendering suddenly goes to 100% after meet first title clip"

Hi, thanks so much for replying. No I do not have a title clip. But I end with "white noise and a picture".

Do you see any crash messages from rendering? I'm asking since I'm experiencing some minor rendering crashes from time to time which leave the resulting video most of the time in working state. Sometimes, the final few seconds are missing. In my cases the problems seem to be triggered by audio encoded with variable bitrate. But this is only a guess.