Sun Nov 11, 2012 6:01 am
I love to use the transform tool during sketch phase, it saves a lot of time. My workflow is as follows:
- select a drawing area
- click the transform tool
- transform the selection
- hit ENTER (to apply transformation)
- deselect the transform tool (e.g. by selecting the freehand tool)
- deselect the selection
I wonder if this can be done with fewer steps.
Wed Nov 14, 2012 10:46 am
I don't think it can be done with less steps.
Registered users: Andreas Mair, andreas_k, Baidu [Spider], Bing [Bot], boudewijn, cylverbak, Deevad, dodinj, Exabot [Bot], firekage, francescobona, Google [Bot], google01103, Honoo, irina_r, jmf, ken300, kilianl, koriun, leinir, Majestic-12 [Bot], malsharif, metzman, MSNbot Media, mykolak, Panz, paulus3005, Sogou [Bot], TheraHedwig, Tromzy, veqz, Xiceph, Yahoo [Bot]