Sun May 10, 2020 3:53 pm
Hi everyone, I noticed that PowerDevil changes power governor in late when I unplug my power supply. I noticed that the switch to battery is detected later than it should.
I read on PowerDevil doc page that it doesn't poll frequently the hardware due to power consuption, could it be the reason of my problem?
However, when i plug the power supply again it is detected immediately, so maybe the cause is not the polling frequency.
Can someone help me with this?
Thanks in advance for replies.
P.S. If nothing can be done with this, I'd like you to advise me a good alternative to PowerDevil.